Chapter 19 Configuration: Port
GS1900 Series User’s Guide
120
19.4.2 The Po rt Sc re e n
Use this screen to view Switch port PoE settings and select ports for configuration. Click Co nfig ura tio n >
Port > PoE > Port to open this screen.
Fig ure 119 Configuration > Port > PoE > Port
The following table describes the labels in this screen.
Power Up
Sequence Delay
This field is only available on GS1900-8HP (Revision B1) and GS1900-10HP only.
Select Ena ble to allow PoE ports to be powered up one-by-one randomly or Disa b le to allow
them all to be powered up at the same time.
Apply Click A pp ly to save the changes.
Cancel Click C a nc e l to discard the changes.
Table 66 Configuration > Port > PoE > Global (continued)
LABEL DESCRIPTIO N
Table 67 Configuration > Port > PoE > Port
LABEL DESCRIPTIO N
Edit Select one or more ports in the first column of the table and click this to configure PoE settings
for the ports.
Port Displays the port index number.
State Displays which ports can receive power from the Switch. You can set this in the C onfig ura tio n >
Po rt > Po E Ed it screen.
• Disa b le – The powered device (PD) connected to this port cannot get power.
• Ena ble – The PD connected to this port can receive power.
To Next Page
Loading...
