ZyXEL Communications GS1900-8HP - The Port Edit Screen

Chapter 20 Configuration: VLAN
GS1900 Series User’s Guide
131
20.2.4 The Po rt Edit Sc re e n
Use this screen to configure port settings. Click Config ura tio n > VLAN > VLA N > Port > Ed it to open this
screen.
Fig ure 128 Configuration > VLAN > VLAN > Port > Edit
The following table describes the labels in this screen.
VLAN Trunk Enable VLAN Trunking on ports connected to other switches or routers (but not ports directly
connected to end users) to allow frames belonging to unknown VLAN groups to pass through
the Switch.
Edit Select this check box to configure the properties of a port. Click the Edit button change the
properties of the port.
Cancel Click C a nc e l to discard the changes.
Table 75 Configuration > VLAN > VLAN > Port (continued)
LABEL DESCRIPTIO N
Table 76 Configuration > VLAN > VLAN > Port > Edit
LABEL DESCRIPTIO N
Port
Port Select Displays the list of port index numbers that are being configured.
PVID Enter a number between 1 and 4094 as the port VLAN ID.
Accepted Type Select All from the drop-down list box to accept all untagged or tagged frames on this port. This
is the default setting.
Select Ta g O nly to accept only tagged frames on this port. All untagged frames will be
dropped.
Select Unta g O nly to accept only untagged frames on this port. All tagged frames will be
dropped.
Ingress Filtering If this check box is selected for a port, the Switch discards incoming frames for VLANs that do
not include this port in its member set.
Clear this check box to disable ingress filtering.
VLAN Trunk Enable VLAN Trunking on ports connected to other switches or routers (but not ports directly
connected to end users) to allow frames belonging to unknown VLAN groups to pass through
the Switch.
Apply Click A pp ly to save the changes.
Cancel Click C a nc e l to discard the changes.