ZyXEL Communications GS1900-8HP - The LAG Port Screen; The LAG Port Edit Screen

Chapter 22 Configuration: Link Aggregation
GS1900 Series User’s Guide
147
22.2.4 The LAG Po rt Sc re e n
Use this screen to view LAG port settings. Click C o nfig ura tio n > Link Ag g re g a tio n > LA G Port to open this
screen.
Fig ure 147 Configuration > Link Aggregation > LAG Port
The following table describes the labels in this screen.
22.2.5 The LAG Po rt Edit Sc re e n
Use this screen to edit a LAG port. Click Config ura tio n > Link Ag g re g a tio n > LA G Po rt > Ed it to open this
screen.
Apply Click A pp ly to save the changes.
Cancel Click C a nc e l to discard the changes.
Table 93 Configuration > Link Aggregation > LAG Management > Add (continued)
LABEL DESCRIPTIO N
Table 94 Configuration > Link Aggregation > LAG Port
LABEL DESCRIPTIO N
LAG Port
LAG Displays the LAG index value.
Name Displays the LAG name.
Port Type Displays the port type.
State Displays the state as Ena ble or Disa ble .
Speed Displays the speed value as Auto, Auto- 10M, A uto - 100M, Auto - 1000M, Auto- 10/ 100M, 10M,
100M, or 1000M.
Duplex Displays the duplex value as Full, Ha lf, or Auto .
FlowCtrl State Displays whether flow control is Ena ble or Disa b le .
FlowCtrl Status Displays whether flow control is in use (Ena ble ) or not (Disa b le ).
Edit Select this check box to configure the properties of a port. Click the Edit button change the
properties of the port.
Cancel Click C a nc e l to discard the changes.