Chapter 27 Configuration: Spanning Tree
GS1900 Series User’s Guide
170
The following table describes the labels in this screen.
27.2.2 The STP Po rt Sc re e n
Use this screen to view the STP Port settings. Click Config ura tio n > Sp a nning Tre e > STP Po rt to open this
screen.
Fig ure 170 Configuration > Spanning Tree > STP Port
Table 116 Configuration > Spanning Tree > Global
LABEL DESCRIPTIO N
Global
State Select to Ena ble or Disa ble the Spanning-Tree function.
BPDU Forward Select the bridge protocol data units forward (BPDU) option to be Flo od ing or Filte ring .
Path Cost
Method
Select Sho rt or Lo ng as a Pa th C ost method.
Path cost is the cost of transmitting a frame on to a LAN through that port. It is recommended
that you assign this value according to the speed of the bridge. The slower the media, the
higher the cost - see Table 40 on page 112 for more information.
Version Select the type of spanning tree protocol to use. The following options are available:
• STP
• RSTP
• MSTP
Configuration
Name
Enter the name of the configuration in hexadecimal. The maximum number characters is 32.
Configuration
Revision
Enter the revision number of configuration. The number can be between 0 and 65535.
Apply Click A pp ly to save the changes.
Cancel Click C a nc e l to discard the changes.
To Next Page
Loading...
