Chapter 32 Configuration: Management
GS1900 Series User’s Guide
219
Fig ure 222 Configuration > Management > SNMP > Group
The following table describes the labels in this screen.
32.3.5 The G ro up Add Sc re e n
Use this screen to configure the G ro up settings. Click Co nfig ura tion > Ma na g e m e nt > SNMP > G roup >
Add to open this screen.
Fig ure 223 Configuration > Management > SNMP > Group > Add
The following table describes the labels in this screen.
Table 170 Configuration > Management > SNMP > Group
LABEL DESCRIPTIO N
SNMPv3 Group
Group Name Displays a string identifying the group name that this entry should belong to. The allowed string
length is 1 to 30, and the allowed content is ASCII characters from 33 to 126.
Security Model Displays the security model that this entry belongs to. Possible security models are:
• a ny: Any security model accepted(v1|v2c|usm).
• v1: Reserved for SNMPv1.
• v2c : Reserved for SNMPv2c.
• usm : User-based Security Model (USM).
Security Level Displays the security model that this entry belongs to. Possible security models are:
• no a uth: No authentication and no privacy.
• a uth: Authentication and no privacy.
• Priv: Authentication and privacy.
Access Right Displays the access mode for this entry. The possible values are Re a d O nly and Re a d- Write .
Action
Delete Click De le te to remove the entry.
Add Click Add to create a new SNMPv3 G ro up entry.
Table 171 Configuration > Management > SNMP > Group > Add
LABEL DESCRIPTIO N
SNMPv3 Group
Group Name Enter a string identifying the group name that this entry should belong to. The allowed string
length is 1 to 30, and the allowed content is ASCII characters from 33 to 126.
To Next Page
Loading...
