ZyXEL Communications GS1900-8HP - The HTTPS Screen

Chapter 32 Configuration: Management
GS1900 Series User’s Guide
225
Fig ure 230 Configuration > Management > HTTP/HTTPS > HTTP
The following table describes the labels in this screen.
32.5.2 The HTTPS Sc re e n
Use this screen to configure the HTTPS settings. Click Config ura tion > Ma na g e m e nt > HTTP/ HTTPS > HTTPS
to open this screen.
Fig ure 231 Configuration > Management > HTTP/HTTPS > HTTPS
The following table describes the labels in this screen.
Table 178 Configuration > Management > HTTP/HTTPS > HTTP
LABEL DESCRIPTIO N
HTTP
State Select the HTTP mode operation.
Possible modes are:
• Ena ble d : Enable HTTP mode operation.
• Disa b le d: Disable HTTP mode operation.
Authentication
Method
Select the authentication method from the dropdown list.
Session Timeout Enter the session timeout value. The timeout can be between 0 and 86400 minutes.
Apply Click A pp ly to save the changes.
Cancel Click C a nc e l to discard the changes.
Table 179 Configuration > Management > HTTP/HTTPS > HTTPS
LABEL DESCRIPTIO N
HTTPS
State Select the HTTPS mode operation.
Possible mode is:
• Ena ble : Enable HTTPS mode operation.
Authentication
Method
Select the authentication method from the dropdown list.