Chapter 33 Maintenance
GS1900 Series User’s Guide
233
Fig ure 239 Maintenance > Firmware > Management
The following table describes the labels shown under Im a g e s Inform a tion.
33.2.2 Se le c t the Ac tive Im a g e
The available partition is shown under Ima g e Se le c t.
Follow the steps below to choose the active image, which will be the default partition during boot.
When you selected the active image and saved the changes, the other one will be the backup.
If you are facing problems with the active partition when booting, the Switch will use the backup one
and it’ll be loaded automatically.
1. In Ac tive Ima g e , choose the backup image according to the information displayed in Ima g e s Info r-
ma tion.
2. Click Ap ply to activate the backup image.
OR
Click Ca nc e l to discard the changes.
Table 187 Maintenance > Firmware > Management
LABEL DESCRIPTIO N
Image Select
Active Image Select which firmware should load, click App ly and reboot the Switch to see changes.
Apply Click A pp ly to save the changes.
Cancel Click C a nc e l to discard the changes.
Images Information
Flash Partition Displays the partition number.
Image Size Displays the size of the partition image in bytes.
Created Time Displays the date and time when the image was created in the Coordinated Universal Time
(UTC) format.
To Next Page
Loading...
