Chapter 33 Maintenance
GS1900 Series User’s Guide
240
33.7.3 IPv6 Ping Te st
Click Ma inte na nc e > Dia g no stic s > PING > IPv6 in the navigation panel to open this screen. Use this
screen to ping an IPv6 server.
Fig ure 245 Maintenance > Diagnostics > PING > IPv6
The following table describes the labels in IPv6 Ping Te st.
Follow the steps to perform a ping test.
1. In IPv6 Addre ss, enter the IPv6 address.
2. In Count, enter the number of ping packets.
3. In Inte rva l, enter the time interval in seconds.
4. In Size , enter the packet size in bytes.
5. Click Ap ply to perform the ping test.
OR
Table 192 Maintenance > Diagnostics > PING > IPv6
LABEL DESCRIPTIO N
IPv6 Ping Test
IPv6 Address Enter the address of the target host server.
Count Enter the number of ping packets to send. The range is 1 to 5 packets; the default count is 4.
Interval Enter the time in seconds between sending ping packets. The range is 1 to 5 seconds; the
default is 1 second.
Size Enter the individual packet size in bytes. The range is 8 to 5120 bytes; the default is 56 bytes.
Apply Click A pp ly to save the changes.
Cancel Click C a nc e l to discard the changes.
To Next Page
Loading...
