GS1900 Series User’s Guide
26
2.5.1.1 Pre c a utio ns
• Make sure the rack will safely support the combined weight of all the equipment it contains.
• Make sure the position of the Switch does not make the rack unstable or top-heavy. Take all
necessary precautions to anchor the rack securely before installing the unit.
2.5.2 Atta c hing the Mo unting Bra c ke ts to the Switc h
1 Position a mounting bracket on one side of the Switch, lining up the four screw holes on the bracket with
the screw holes on the side of the Switch.
Fig ure 7 Attaching the Mounting Brackets (GS1900-16, GS1900-24E, and GS1900-24EP)
Fig ure 8 Attaching the Mounting Brackets (GS1900-24, GS1900-24HP/GS1900-24HPv2, GS1900-48, and
GS1900-48HP/GS1900-48HPv2)
2 Using a #2 Philips screwdriver, install the M3 flat head screws through the mounting bracket holes into
the Switch.
3 Repeat steps
1 and 2 to install the second mounting bracket on the other side of the Switch.
4 You may now mount the Switch on a rack. Proceed to the next section.
2.5.3 Mo unting the Switc h o n a Ra c k
1 Position a mounting bracket (that is already attached to the Switch) on one side of the rack, lining up
the two screw holes on the bracket with the screw holes on the side of the rack.
To Next Page
Loading...
