Chapter 32 Link Layer Discovery Protocol (LLDP)
GS1920 Series User’s Guide
272
The following table describes the labels in this screen.
Table 131 Advanced Application > LLDP > LLDP-MED Location
LABEL DESCRIPTION
Port Enter the port number you want to set up the location within the LLDP-MED network.
Location
Coordinates
The LLDP-MED uses geographical coordinates and Civic Address to set the location
information of the remote device. Geographical based coordinates includes latitude,
longitude, altitude and datum. Civic Address includes Country, State, County, City,
Street and other related information.
Latitude Enter the latitude information. The value should be from 0º to 90º. The negative value
represents the South.
•north
•south
Longitude Enter the longitude information. The value should be from 0º to 180º. The negative
value represents the West.
•west
•east
Altitude Enter the altitude information. The value should be from -2097151 to 2097151 in meters
or in floors.
• meters
• floor
Datum Select the appropriate geodetic datum used by GPS.
•WGS84
•NAD83-NAVD88
•NAD83-MLLW
Civic Address
Enter the Civic Address by providing information such as Country, State, County, City,
Street, Number, ZIP code and other additional information. Enter at least two field in this
configuration including the Country. The valid length of the Country field is 2 characters
and all other fields are up to 32 characters.
•Country
•State
•County
•City
• Division
• Neighbor
•Street
• Leading-Street-Direction
• Street-Suffix
• Trailing-Street-Suffix
•House-Number
• House-Number-Suffix
• Landmark
• Additional-Location
•Name
•Zip-Code
•Building
•Unit
• Floor
• Room-Number
•Place-Type
• Postal-Community-Name
•Post-Office-Box
• Additional-Code
To Next Page
Loading...
