ZyXEL Communications GS2200-24 Series - Link Aggregation Control Protocol

Chapter 17 Link Aggregation
GS2200-24/24P User’s Guide
163
17.4 Link Aggregation Control Protocol
Click Advanced Application > Link Aggregation > Link Aggregation Setting
> LACP to display the screen shown next. See Section on page 158 for more
information on dynamic link aggregation.
Figure 84 Advanced Application > Link Aggregation > Link Aggregation Setting >
LACP
The following table describes the labels in this screen.
Table 43 Advanced Application > Link Aggregation > Link Aggregation Setting >
LACP
LABEL DESCRIPTION
Link
Aggregation
Control
Protocol
Note: Do not configure this screen unless you want to enable
dynamic link aggregation.
Active Select this checkbox to enable Link Aggregation Control Protocol (LACP).