ZyXEL Communications GS2200-8HP - Page 7

PoE Support Note
All contents copyright (c) 2011 ZyXEL Communications Corporation.
7
Configuration using the CLI
Command Examples
1. Enable PoE on port interface and set usage threshold and MIB traps.
sysname# configure
sysname(config)# pwr interface 1-4
sysname(config)# pwr usagethreshold 25
sysname(config)# pwr mibtrap
sysname(config)# exit
2. Check the PoE status in CLI
GS2200# sh pwr