ZyXEL Communications GS3700 Series - Spanning Tree Configuration

Chapter 11 Spanning Tree Protocol
GS3700/XGS3700 Series User’s Guide
137
Figure 91 Advanced Application > Spanning Tree Protocol (Standalone mode)
Figure 92 Advanced Application > Spanning Tree Protocol (Stacking mode)
This screen differs depending on which STP mode (RSTP, MRSTP or MSTP) you configure on the
Switch. This screen is described in detail in the section that follows the configuration section for
each STP mode. Click Configuration to activate one of the STP standards on the Switch.
11.3 Spanning Tree Configuration
Use the Spanning Tree Configuration screen to activate one of the STP modes on the Switch.
Click Configuration in the Advanced Application > Spanning Tree Protocol.
Figure 93 Advanced Application > Spanning Tree Protocol > Configuration