Chapter 14 Mirroring
GS3700/XGS3700 Series User’s Guide
167
14.1.2 Remote Port Mirroring
Use this screen to create a remote port mirroring (RMirror) VLAN through which the mirrored traffic
is forwarded.
Click the RMirror link in the Advanced Application > Mirroring screen. The following screen
opens.
Figure 111 Advanced Application > Mirroring > RMirror
The following table describes the labels in this screen.
Apply Click Apply to save your changes to the Switch’s run-time memory. The Switch loses these
changes if it is turned off or loses power, so use the Save link on the top navigation panel to
save your changes to the non-volatile memory when you are done configuring.
Cancel Click Cancel to begin configuring this screen afresh.
Table 69 Advanced Application > Mirroring (continued)
LABEL DESCRIPTION
Table 70 Advanced Application > Mirroring > RMirror
LABEL DESCRIPTION
Active Select the option to enable the VLAN.
RMirror VLAN ID Specify the ID number of remote port mirroring (RMirror) VLAN.
Apply Click Apply to save your changes to the Switch’s run-time memory. The Switch loses
these changes if it is turned off or loses power, so use the Save link on the top
navigation panel to save your changes to the nonvolatile memory when you are done
configuring.
Cancel Click Cancel to begin configuring this screen afresh.
VLAN This field displays the ID number of the RMirror VLAN. Click on the VLAN ID number to
change the settings.
Select an entry’s check box to select a specific entry. Otherwise, select the check box
in the table heading row to select all entries.
Active This field displays whether the VLAN is enabled or not.
Delete Check the rule(s) that you want to remove and then click the Delete button.
Cancel Click Cancel to clear the selected checkbox(es).
To Next Page
Loading...
