Chapter 25 IP Source Guard
GS3700/XGS3700 Series User’s Guide
288
The following table describes the labels in this screen.
25.11 IPv6 Static Binding Setup
Use this screen to manually create an IPv6 source guard binding table entry and manage IPv6
static bindings. Static bindings are uniquely identified by the source IPv6 address / prefix. Each
source IPv6 address / prefix can only be in one static binding. If you try to create a static binding
with the same source IPv6 address / prefix as an existing static binding, the new static binding
replaces the original one. To open this screen, click Advanced Application > I P Source Guard >
I Pv6 Static Binding Setup.
Table 135 Advanced Application > IP Source Guard > IPv6 Source Binding Status (Standalone
mode)
LABEL DESCRIPTION
Clear Dynamic
Source Binding
Specify how you want the Switch to remove dynam ic IPv6 source binding entries when
you click Flush.
• Select All to remove all of the dynamic entries from the IPv6 source binding table.
• Select I Pv6 Address and enter an IPv6 address to remove the dynamic entries
snooped with the specified IPv6 address.
• Select I Pv6 Prefix and enter a Prefix address to remove the dynamic entries snooped
with the specified Prefix address.
Flush Click this to remove dynamic IPv6 source binding entries according to your selections.
Cancel Click this to reset the values above based or if not applicable, to clear the fields above.
Index This field displays a sequential number for each binding.
Source Address This field displays the source IP address in the binding. If the entry is blank, this field will
not be checked in the binding.
MAC Address This field displays the source MAC address in the binding. If the entry is blank, this field
will not be checked in the binding.
VLAN This field displays the source VLAN ID in the binding. If the entry is blank, this field will
not be checked in the binding.
Port This field displays the port number in the binding. If this field is blank, the binding applies
to all ports.
Lease This field displays how many days, hours, minutes, and seconds the binding is valid; for
example, 2d3h4m 5 s means the binding is still valid for 2 days, 3 hours, 4 minutes, and 5
seconds. This field displays infinity if the binding is always valid (for example, a static
binding).
Type This field displays how the Switch learned the binding.
S: This static binding was learned from information provided manually by an
administrator.
DH: This dhcp-snooping binding was learned by snooping DHCP packets.
To Next Page
Loading...
