ZyXEL Communications GS3700 Series - Page 289

Chapter 25 IP Source Guard
GS3700/XGS3700 Series User’s Guide
289
Figure 200 Advanced Application > IP Source Guard > IPv6 Static Binding Setup (Standalone
mode)
The following table describes the labels in this screen.
Table 136 Advanced Application > IP Source Guard > IPv6 Static Binding Setup (Standalone mode)
LABEL DESCRIPTION
IPv6 Static
Binding
Source Address Enter the IPv6 address or IPv6 prefix and prefix length in the binding.
MAC Address Enter the source MAC address in the binding. If this binding doesn’t check this field, select
Any.
Note: You cannot choose Any for all three of MAC Address, VLAN and Port. You must fill
in at least one.
VLAN Enter the source VLAN ID in the binding. If this binding doesn’t check this field, select
Any.
Port Specify the port(s) in the binding. If this binding has one port, select the first radio button
and enter the port number in the field to the right. If this binding applies to all ports,
select Any.
Add Click this to create the specified static binding or to update an existing one.
Cancel Click this to reset the values above based or if not applicable, to clear the fields above.
Clear Click this to clear the fields above.
Index This field displays a sequential number for each binding.
Source Address This field displays the IPv6 address or IPv6 prefix and prefix length in the binding.
MAC Address This field displays the source MAC address in the binding. If the entry is blank, this field
will not be checked in the binding.
VLAN This field displays the source VLAN ID in the binding. If the entry is blank, this field will
not be checked in the binding.
Port This field displays the port number in the binding. If this field is blank, the binding applies
to all ports.
Delete Select an entry checkbox and click Delete to rem ove the specified entry.
Cancel Click this to clear the Delete check boxes above.