Chapter 31 Error Disable
GS3700/XGS3700 Series User’s Guide
326
31.2 The Error Disable Screen
Use this screen to configure error disable related settings. Click Advanced Application >
Errdisable in the navigation panel to open the following screen.
Figure 234 Advanced Application > Errdisable
The following table describes the labels in this screen.
31.3 Error-Disable Status
Use this screen to view whether the Switch detected that control packets exceeded the rate limit
configured for a port or a port is disabled according to the feature requirements and what action
you configure, and related information. Click the Click here link next to Errdisable Status in the
Advanced Application > Errdisable screen to display the screen as shown.
Table 157 Advanced Application > Errdisable
LABEL DESCRIPTION
Errdisable Status Click this link to view whether the Switch detected that control packets exceeded the
rate limit configured for a port or a port is disabled according to the feature
requirements and what action you configure, and related information.
CPU protection Click this link to limit the maximum number of control packets (ARP, BPDU and/ or
IGMP) that the Switch can receive or transmit on a port.
Errdisable Detect Click this link to have the Switch detect whether the control packets exceed the rate
limit configured for a port and configure the action to take once the limit is exceeded.
Errdisable Recovery Click this link to set the Switch to automatically undo an action after the error is gone.
To Next Page
Loading...
