Chapter 35 Link Layer Discovery Protocol (LLDP)
GS3700/XGS3700 Series User’s Guide
366
The following table describes the labels in this screen.
35.8 LLDP-MED Network Policy
Click Advanced Application > LLDP > LLDP-MED Netw ork Policy to display the screen as
shown next.
Figure 268 Advanced Application > LLDP > LLDP-MED Network Policy (Standalone mode)
Table 177 Advanced Application > LLDP > LLDP-MED Configuration
LABEL DESCRIPTION
Slot (Stacking
mode)
This field appears only in stacking mode. Click the drop-down list to choose the slot
number of the Switch in a stack.
Port This displays the Switch’s port number. Select * to configure all ports (in the same
Switch) simultaneously. In Stacking mode, the first number means Slot ID and the
second is the port.
Notification
Topology
Change
Select to enable LLDP-MED topology change traps on this port.
MED TLV Setting
Location Select to enable transmitting LLDP-MED location TLV.
Network Policy Select to enable transmitting LLDP-MED Network Policy TLV.
Apply Click Apply to save the changes to the Switch’s run-time memory. The Switch loses
these changes if it is turned off or loses power, so use t he Save link on the t op navigat ion
panel to save your changes to the non-volatile memory when you are done configuring.
Cancel Click Cancel to begin configuring this screen afresh.
To Next Page
Loading...
