ZyXEL Communications GS3700 Series - Page 367

Chapter 35 Link Layer Discovery Protocol (LLDP)
GS3700/XGS3700 Series User’s Guide
367
Figure 269 Advanced Application > LLDP > LLDP-MED Network Policy (Stacking mode)
The following table describes the labels in this screen.
Table 178 Advanced Application > LLDP > LLDP-MED Network Policy
LABEL DESCRIPTION
Port Enter the port number to set up the LLDP-MED network policy. For Stacking mode the
first field box is the Slot ID, the second field box is the port.
Application Type Select the type of application used in the network policy.
• voice
• voice-signaling
• guest-voice
• guest-voice-signaling
• softphone-voice
• video-conferencing
• streaming-video
• video-signaling
Tag Select to tag or untag in the network policy.
• tagged
• untagged
VLAN Enter the VLAN ID number. It should be from 1 to 4094. For priority tagged frames, enter
“0”.
DSCP Enter the DSCP value of the network policy. The value is defined from 0 through 63 with
the 0 representing use of the default DSCP value.
Priority Enter the priority value for the network policy.
Add Click Add after finish entering the network policy information. A summary table will list
all the Switch you’ve added.
Cancel Click Cancel to begin entering the information afresh.
Index This field displays the of index number of the network policy. Click an index number to
edit the rule.
Port This field displays the port number of the network policy. In stacking mode, the first
number represents the slot and the second the port number.
Application Type This field displays the application type of the network policy.
Tag This field displays the Tag Status of the network policy.
VLAN This field displays the VLANID of the network policy.
Priority This field displays the priority value of the network policy.