Chapter 40 Static Route
GS3700/XGS3700 Series User’s Guide
398
40.4 Configuring IPv6 Static Routing
Click the link next to I Pv6 Static Route in the I P Application > Static Routing screen to display
the screen as shown.
Figure 290 IP Application > Static Routing > IPv6 Static Route
Add Click Add to insert a new static route to the Switch’s run-time memory. The Switch loses
these changes if it is turned off or loses power, so use the Save link on the top navigation
panel to save your changes to the non-volatile memory when you are done configuring.
Cancel Click Cancel to begin configuring this screen afresh.
Clear Click Clear to set the above fields back to the factory defaults.
Index This field displays the index number of the route. Click a number to edit the static route
entry.
Active This field displays Yes when the static route is activated and NO when it is deactivated.
Name This field displays the descriptive name for this route. This is for identification purposes
only.
Destination
Address
This field displays the I P network address of the final destination.
Subnet Mask This field displays the subnet mask for this destination.
Gateway
Address
This field displays the IP address of the gateway. The gateway is the immediate neighbor of
your Switch that will forward the packet to the destination.
Metric This field displays the cost of transmission for routing purposes.
Select an entry’s check box to select a specific entry. Otherwise, select the check box in the
table heading row to select all entries.
Delete Click Delete to remove the selected entry from the summary table.
Cancel Click Cancel to clear the check boxes.
Table 192 IP Application > Static Routing > IPv4 Static Route (continued)
LABEL DESCRIPTION
To Next Page
Loading...
