ZyXEL Communications GS3700 Series - Page 437

Chapter 44 VRRP
GS3700/XGS3700 Series User’s Guide
437
Figure 329 VRRP Configuration Example: Two Virtual Router Network
You need to configure the VRRP Configuration screen for virtual router VR2 on each switch, while
keeping the VRRP configuration in example 1 for virtual router VR1 (refer to
Section 44.4.2 on
page 436). Configure the VRRP parameters on the switches as shown in the figures below.
Figure 330 VRRP Example 2: VRRP Parameter Settings for VR2 on Switch A
Figure 331 VRRP Example 2: VRRP Parameter Settings for VR2 on Switch B
After configuring and saving the VRRP configuration, the VRRP Status screens for both switches
are shown next.
172.16.1.10 0
172.16.1.1
172.16.1.10
EXAMPLE
EXAMPLE