ZyXEL Communications IES-1000 - DVLAN Getentry Command; VLAN List Command

IES-1000 User’s Guide
IEEE 802.1Q Tagged VLAN Commands 31-9
Figure 31-6 Example: DVLAN List Command Display
In the figure above, “||” denotes “filter” and “>>” denotes “forward”.
31.3.10 DVLAN Getentry Command
Syntax:
192.168.1.1 vlan1q> dvlan getentry <vid>
where
<vid> =
A VLAN ID. Valid parameter range = [1 – 4094].
This command displays an entry with a specified VLAN ID in dynamic GVRP table.
Display a Dynamic VLAN Table Entry Example
The following figure is an example display of the following command.
192.168.1.1 vlan1q> dvlan getentry 2
Figure 31-7 Example: DVLAN Getentry 2 Command Display
In the figure above, “||” denotes “filter” and “>>” denotes “forward”.
31.3.11 VLAN List Command
Syntax:
192.168.1.1 vlan1q> vlan list
This command displays the entire VLAN table. The display refreshes periodically. Press [ENTER] and then
enter the stop command to stop the display from refreshing. The following figure is an example what is
displayed when you use this command.
vid 01 02 03 04 05 06 07 08 09
---- ---- ---- ---- ---- ---- ---- ---- ---- ----
2
||
>>
||
||
>
>
>
>
||
||
>
>
vid 01 02 03 04 05 06 07 08 09
---- ---- ---- ---- ---- ---- ---- ---- ---- ----
2 || >> || || >> >> || || >>
3 >> >> || || || >> >> >> ||
4 >> || || >> >> || || >> >>
5 || >> || || >> >> || || >>
6 >> >> || || || >> >> >> ||
7 || >> || >> >> || || >> >>
8 >> || || >> || >> >> >> >>
9
||
>>
||
||
||
>
>
||
>>
>
>