ZyXEL Communications IES-1000 - Figure 36-1 BOOTP;TFTP Server; Figure 36-2 Input MAC

IES-1000 User’s Guide
Firmware Upload and Recovery 36-3
4.
Run BootpTftp.exe, to bring up the following window. Click New to create a MAC address entry.
Figure 36-1 BOOTP/TFTP Server
5. The Input Box window will pop up as shown next. Type the MAC address of the network module and
then click OK. You can find the MAC address of the network module on its boot console.
Figure 36-2 Input MAC
6. Type the host IP address (the IP address you want to assign to the network module), server IP address
(the IP address of this computer), net mask, gateway and filename (the new firmware name) into the
appropriate fields in the screen shown next. Click Update Database.