IES-1000 User’s Guide
Removing and Installing Network Modules 5-1
This chapter shows you how to remove and install network modules.
Each IES-1000 accommodates up to two network modules. Remove and install modules via the front of the IES-
1000. The figure below shows the front view of a SAM1008 network module; the procedures for removing and
installing AAM1008 network modules are the same.
Figure 5-1 IES-1000 G.SHDSL SAM1008 Network Module
5.1 Removing a G.SHDSL SAM1008 Network Module
Step 1. Loosen the two screws on the front panel that secure the module to the chassis by turning them counter-
clockwise as shown next.
Figure 5-2 Loosen Module Screws
Step 2. Gently pull the network module out of the chassis as shown next.
Chapter 5
Removing
and Installing Network Modules
To Next Page
Loading...
