IES-1000 User’s Guide
Hardware Connections 6-11
Figure 6-11 Installation Scenario C
Procedure To Connect To MDFs
Step 1. Acquire two additional MDFs (3 and 4).
Step 2. Connect the RJ-11 connector ends of telephone wires you want for ADSL service to the USER ports
on the AAM1008.
Step 3. Connect the other ends of the telephone wires to the upper ports of MDF 3 using a punch-down tool.
Step 4. Connect the lower ports of MDF 3 to the upper ports of MDF 2 for those users that want ADSL
service. (Users who want telephone service only, retain the original connection from the top port of
MDF 2 to the bottom port of MDF 1.)
Step 5. Connect the telephone wiring from the end-user’s ADSL equipment to the lower ports of MDF 2.
Step 6. Connect the RJ-11 connector ends of telephone wires you want for voice service to the AAM1008’s
CO ports.
Step 7. Connect the other ends of the telephone wires to the lower ports of MDF 4 using a punch-down tool.
Step 8. Connect the top ports of MDF 4 to the bottom ports of MDF 1 using regular telephone wires.
To Next Page
Loading...
