Chapter 4 Tutorials
LTE3302-M432 & LTE3312-M432 User’s Guide
34
4.2.1 Push Button Configuration (PBC)
1 Make sure that your LTE Device is turned on. Make sure the wireless LAN is turned on by pressing the
WLAN/WPS button for less than five seconds, and that the device is placed within range of your
notebook.
2 WPS is enabled by default on the LTE Device. If not, log into LTE Device’s Web Configurator and press the
Push Button in the Configuration > Network > Wireless LAN 2.4G > WPS Station screen. You can either
press the WPS button on the LTE Device’s top panel or press Push Button in the screen.
3 Go to your phone settings and turn on Wi-Fi. Open the Wi-Fi networks list and tap WPS Push Button or the
WPS icon ( ).
Note: It doesn’t matter which button is pressed first. You must press the second button within
two minutes of pressing the first one.
The LTE Device sends the proper configuration settings to the wireless client. This may take up to two
minutes. Then the wireless client is able to communicate with the LTE Device securely.
The following figure shows you an example to set up wireless network and security by pressing a button
on both LTE Device and wireless client (the Android smartphone in this example).
Figure 24 Example WPS Process: PBC Method
Wireless Client
SECURITY INFO
COMMUNICATION
WITHIN 2 MINUTES
LTE
LTE
To Next Page
Loading...
