Chapter 6 Home Network
LTE7460-M608 User’s Guide
43
Figure 24 Home Network > DHCP
The following table describes the labels in the screen.
Table 13 Home Network > DHCP
LABEL DESCRIPTION
DHCP Settings
Enable DHCP Server Select the check box to enable the DHCP server on the LTE7460-M608.
Start IP The LTE7460-M608 is pre-configured with a pool of 241 IP addresses starting from
192.168.1.10 to 192.168.1.250.
This field specifies the first of the continuos addresses in the IP address pool.
End IP This field specifies the last of the continuos addresses in the IP address pool.
Lease Time Specify how long (in minutes) each computer can use the information (especially
the IP address).
Static DHCP List
Add New Click Add New to create a new entry.
This field displays the index number of the IP address entry.
IP Address This field displays the IP address that the LTE7460-M608 assigns to a device with the
entry’s MAC address.
MAC address This field displays the MAC address of the device to which the LTE7460-M608 assigns
the entry’s IP address.
Action Click Edit to go to the screen where you can edit the static IP address.
Click Delete to remove the static IP address entry.
Apply Click Apply to save your changes back to the LTE7460-M608.
Reset Click Reset to reload the previous configuration for this screen.
To Next Page
Loading...
