ZyXEL Communications MGS3520 Series - MLD Snooping-Proxy; MLD Snooping-Proxy VLAN

Chapter 25 Multicast
MGS3520 Series User’s Guide
209
25.4.1 MLD Snooping-proxy
Click the MLD Snooping-proxy link in the Advanced Application > Multicast > IPv6 Multicast
screen to display the screen as shown. See Section 25.1 on page 200 for more information on
multicasting.
Figure 119 Advanced Application > Multicast > IPv6Multicast > MLD Snooping-proxy
The following table describes the fields in the above screen.
25.4.2 MLD Snooping-proxy VLAN
Click the VLAN link in the Advanced Application > Multicast > IPv6 Multicast > MLD
Snooping-proxy screen to display the screen as shown. See Section 25.1 on page 200 for more
information on multicasting.
Multicast Group This field displays IP multicast group addresses.
Group Timeout This field displays the time (in seconds) that elapses before the Switch removes a MLD
group membership entry if it does not receive report messages from the port.
Table 87 Advanced Application > Multicast > IPv6 Multicast
LABEL DESCRIPTION
Table 88 Advanced Application > Multicast > IPv6 Multicast > MLD Snooping-proxy
LABEL DESCRIPTION
MLD Snooping-proxy Use these settings to configure MLD snooping-proxy.
Active Select Active to enable MLD snooping-proxy on the Switch to minimize MLD control
messages and allow better network performance.
802.1p Priority Select a priority level (0-7) to which the Switch changes the priority in outgoing MLD
messages.
Unknown Multicast
Frame
Specify the action to perform when the Switch receives an unknown multicast frame.
Select Flooding to send the frame(s) to all ports. Select Drop to discard the
frame(s).
Apply Click Apply to save your changes to the Switch’s run-time memory. The Switch loses
these changes if it is turned off or loses power, so use the Save link on the top
navigation panel to save your changes to the non-volatile memory when you are
done configuring.
Cancel Click Cancel to begin configuring this screen afresh.