Chapter 25 Multicast
MGS3520 Series User’s Guide
214
Figure 122 Advanced Application > Multicast > IPv6 Multicast > MLD Snooping-proxy > Filtering
The following table describes the fields in the above screen.
Table 91 Advanced Application > Multicast > IPv6 Multicast > MLD Snooping-proxy > Filtering
LABEL DESCRIPTION
Active Select this option to enable MLD filtering on the Switch.
Port This field displays the port number.
* Settings in this row apply to all ports.
Use this row only if you want to make some settings the same for all ports. Use this
row first to set the common settings and then make adjustments on a port-by-port
basis.
Changes in this row are copied to all the ports as soon as you make them.
Group Limit Select this option to limit the number of multicast groups this port is allowed to join.
Max Group Num. Enter the number of multicast groups this port is allowed to join. Once a port is
registered in the specified number of multicast groups, any new MLD Report message
is dropped on this port.
Filtering Profile Select the name of the MLD filtering profile to use for this port. Otherwise, select
Default to prohibit the port from joining any multicast group.
You can create MLD filtering profiles in the Multicast > IPv6 Multicast > MLD
Snooping-proxy > Filtering > Filtering Profile screen.
Apply Click Apply to save your changes to the Switch’s run-time memory. The Switch loses
these changes if it is turned off or loses power, so use the Save link on the top
navigation panel to save your changes to the non-volatile memory when you are done
configuring.
Cancel Click Cancel to reset the fields to your previous configuration.
To Next Page
Loading...
