Chapter 27 IP Source Guard
MGS3520 Series User’s Guide
241
Figure 140 Advanced Application > IP Source Guard > Static Binding
The following table describes the labels in this screen.
Table 105 Advanced Application > IP Source Guard > Static Binding
LABEL DESCRIPTION
ARP Freeze ARP Freeze allows you to automatically create static bindings from the current ARP entries
(either dynamically learned or static ARP entries) until the Switch’s binding table is full.
Note: The ARP learning mode should be set to ARP-Request in the IP Application > ARP
Setup > ARP Learning screen before you use the ARP Freeze feature.
Condition All - Select this and click ARP Freeze to have the Switch automatically add all the current
ARP entries to the static bindings table.
Port List - Select this and enter the number of the port(s) (separated by a comma). ARP
entries learned on the specified port(s) are added to the static bindings table after you click
ARP Freeze.
VLAN List - Select this and enter the ID number of the VLAN(s) (separated by a comma).
ARP entries for the specified VLAN(s) are added to the static bindings table after you click
ARP Freeze.
Static Binding
MAC Address Enter the source MAC address in the binding.
IP Address Enter the IP address assigned to the MAC address in the binding.
VLAN Enter the source VLAN ID in the binding.
Port Specify the port(s) in the binding. If this binding has one port, select the first radio button
and enter the port number in the field to the right. If this binding applies to all ports, select
Any.
Add Click this to create the specified static binding or to update an existing one.
To Next Page
Loading...
