Chapter 41 Maintenance
MGS3520 Series User’s Guide
341
Figure 219 Management > Maintenance > Reboot System
The following table describes the labels in this screen.
Table 167 Management > Maintenance > Reboot System
LABEL DESCRIPTION
Reboot Scheduled in This displays the number of days, hours, minutes and/or seconds remaining before the
Switch restarts. It also shows the date and time at which the Switch is scheduled to
restart automatically.
Reboot Reason This shows the reason for the restart.
Boot Image This displays which firmware (1 or 2) should load when the Switch restarts and which
firmware is currently in use on the Switch (1 or 2).
Configuration File This displays which configuration file (1 or 2) should load when the Switch restarts and
which configuration file is currently in use on the Switch (1 or 2).
Refresh Click Refresh to update the time information in the Reboot Scheduled in field.
Cancel Click Cancel to disable the scheduled restart and reset the screen to its default
settings.
Reboot System Select Immediately to have the Switch restart right after you click Apply.
Select Delayed (in 24 days) to schedule a time for the restart to happen.
• Select in to specify how many hours and minutes remain for the restart.
• Select at to configure a specific time of the day, at which the Switch restarts. You
can also specify a date within 24 days of today’s date.
Reason Enter a description for the restart.
Configuration File Select the configuration files you want the Switch to use when it restarts.
Apply Click Apply to save your changes to the Switch’s run-time memory. The Switch loses
these changes if it is turned off or loses power.
To Next Page
Loading...
