ZyXEL Communications MGS3700-12C - Rmirror Configuration

Chapter 16 Mirroring
MGS3700-12C User’s Guide
178
Figure 81 Rmirror Architecture
16.2.2 RMirror Configuration
ClickAdvancedApplication>Mirroring>RMirrorontheuprightofthenavigation
paneltodisplaytheRMirrorscreen.UsethisscreentoactiveRMirrorandsetitsVLAN
ID.
Table 37 Design and Implementation Constraints
CHARACTER PREREQUISITES
Sourceswitch • Hardware support RMirror feature
• In order to mirror control packets, it must support
classification of RMirror VLAN to forwarding.
• RMirror with reflector-port can connected to several
intermediate switches and destination switches by connected-
port.
Intermediateswitch • The RMirror VLAN traffic must pass through connected port.
• In order to mirror control packets, it SHOULD support
classification for RMirror VLAN forwarding.
• Learning SHOULD be disabled on VLAN
• For other supplier switch device, it MUST support 802.1q for
basis function on RMirror. If user wants to have fully support
on RMirror, condition 2 and 3 should be considered.
Designationswitch • The RMirror VLAN traffic must pass through connected port.
• In order to mirror control packets, it SHOULD support
classification for RMirror VLAN forwarding.
• Learning SHOULD be disabled on VLAN
• For other supplier switch device, it MUST support 802.1q for
basis function on RMirror. If user wants to have fully support
on RMirror, condition 2 and 3 should be considered.