Chapter 17 Link Aggregation
MGS3700-12C User’s Guide
193
1 Make your physical connections - make sure that the ports that you want to
belong to the trunk group are connected to the same destination. The following
figure shows ports 2-5 on switch A connected to switch B.
Figure 89 Trunking Example - Physical Connections
2 Configure static trunking - Click Advanced Application > Link Aggregation
> Link Aggregation Setting. In this screen activate trunking group T1, select
the traffic distribution algorithm used by this group and select the ports that
should belong to this group as shown in the figure below. Click Apply when you
are done.
Figure 90 Trunking Example - Configuration Screen
To Next Page
Loading...
