Chapter 23 VLAN Stacking
MGS3700-12C User’s Guide
234
23.4 Configuring VLAN Stacking
Click Advanced Applications > VLAN Stacking to display the screen as shown.
Note: You can not enable VLAN mapping and VLAN stacking at the same time.
Figure 108 Advanced Application > VLAN Stacking
The following table describes the labels in this screen.
Table 62 802.1Q Frame
DA Destination Address Priority 802.1p Priority
SA Source Address Len/
Etype
Length and type of Ethernet
frame
Tunnel
TPID
Tag Protocol IDentifier added on a
tunnel port
Data Frame data
VID VLAN ID FCS Frame Check Sequence
Table 63 Advanced Application > VLAN Stacking
LABEL DESCRIPTION
Active Select this to enable VLAN stacking on the Switch.
Port The port number identifies the port you are configuring.
To Next Page
Loading...
