ZyXEL Communications MSC1000G - Sys Server Show Command

Chapter 34 sys Commands
Management Switch Card User’s Guide
1052
34.3.31 sys server show Command
Syntax:
sys server show
This command displays the system’s service access control settings. The following is an example.
34.4 sys snmp Commands
Use these commands to configure the system’s SNMP settings.
34.4.1 sys snmp getcommunity Command
Syntax:
sys snmp getcommunity <community>
where
Enter this command with the community to set the password.
The following example sets the password for incoming Get- and GetNext requests to “Get123”.
34.4.2 sys snmp setcommunity Command
Syntax:
sys snmp setcommunity <community>
where
ras> sys server show
server status port
------ ------ -----
telnet V 23
ftp V 21
web V 80
icmp V -
snmp V 161
ssh V 22
ras>
<community> =
The password for the incoming Get- and GetNext- requests from the
management station.
ras> sys snmp getcommunity Get123
<community> =
The password for the incoming Set- requests from the management station.