ZyXEL Communications MSC1000G - Sys Snmp Version Command

Chapter 34 sys Commands
Management Switch Card User’s Guide
1055
34.4.7 sys snmp version Command
Syntax:
sys snmp version v2c|v3|v3v2c
where
This command sets the system to use the specified SNMP version and access mode.
The following example configures the system to use SNMPv3 with read-only access for SNMPv2.
34.5 sys syslog Commands
Use these commands to configure the system’s syslog settings.
34.5.1 sys syslog server Command
Syntax:
sys syslog server <fac> <ip-address>
where
This command sets the syslog server’s IP address and log facility.
The following example sets a syslog server log facility of 3 and IP address of 192.168.1.43.
v2c|v3|v3v2c =
Sets the SNMP version and access mode.
v2c: SNMPv2 read/write
v3: SNMPv3 read/write with additional user authentication and data
encryption options.
v3v2c: SNMPv3 read/write and SNMPv2 read-only.
ras> sys snmp version v3v2c
<fac> =
Sets the log facility (local1~local7) to log the syslog messages to a specific file
in the syslog server. See your syslog program’s documentation for details. Sets
the syslog server IP address.
<ip-address> =
The IP address of the syslog server.
ras> sys syslog server local3 192.168.1.43