Management Switch Card User’s Guide 1059
CHAPTER 35
vlan Commands
This chapter shows you how to use the vlan commands.
35.1 vlan Commands Overview
The vlan commands are for static VLAN management.
35.2 vlan Commands Summary
The following table lists the vlan commands. The P column on the right indicates the administrator
privilege level needed to use the command.
35.3 vlan Commands
Use the vlan commands to configure static VLANs (SVLANs).
35.3.1 vlan delete Command
Syntax:
vlan delete <vid>
This command removes a static VLAN.
Table 389 vlan Commands
COMMAND DESCRIPTION P
vlan delete <vid>
Removes a static VLAN. 8
disable <vid>
Turns off a VLAN. 8
enable <vid>
Turns on a VLAN. 8
name <vid> <name>
Sets the name of a VLAN. 8
set <vid> <giga-port>
fix|forbid|normal tag|untag
Adds a static VLAN. 8
show [<vid>]|[<start-vid> <end-
vid>]
Displays all VLANs’ settings, a specified
VLAN’s settings or a range of static VLANs’
settings.
1
To Next Page
Loading...
