Chapter 36 voip Commands
Management Switch Card User’s Guide
1070
• Pay-signal type
36.3.1 voip countrycode set Command
Syntax:
ras> voip countrycode set <country>|<countrycode>
where
Use this command to configure regional settings for VoIP parameters. By default the VoIP line card
is configured for use in the USA (countrycode 0).
The following example configures the VoIP line card for use in the Czech Republic.
<country> <countrycode><country> <countrycode>
usa 0 germany 23
japan 1 greece 24
taiwan 2 australia 25
austria 3 new zealand 26
belgium 4 hong kong 27
bulgaria 5 singapore 28
czech 6 morocco 29
denmark 7 ireland 30
finland 8 malaysia 31
france 9 russia 32
hungary 10 thailand 33
iceland 11 israel 34
italy 12 uae 35
luxembourg 13 china 36
netherlands 14 ukraine 37
norway 15 south_africa 38
poland 16 south_korea 39
portugal 17 philippines 40
slovakia 18 india 41
spain 19 turkey 42
sweden 20 vietnam 43
switzerland 21 brazil 44
uk 22 iran 45
ras> voip countrycode set 6
To Next Page
Loading...
