ZyXEL Communications MSC1000G - Voip Pots Ring Pattern Command

Chapter 36 voip Commands
Management Switch Card User’s Guide
1082
36.10.2 voip pots ring pattern Command
Syntax:
voip pots ring pattern <index> DEFVAL
or
voip pots ring pattern <index> <on1> <off1>
or
voip pots ring pattern <index> <on1> <off1> <on2> <off2>
or
voip pots ring pattern <index> <on1> <off1> <on2> <off2> <on3> <off3>
Use this command to set the specified POTS ring pattern. DEFVAL uses the default ring cadence
according to the country code setting. Otherwise enter the lengths in milliseconds of the first period
of ringing, the first silent interval, the second period of ringing, the second silent interval, the third
period of ringing, and the third silent interval. The first ringing period and silent interval are
required.
The following example sets the first ring pattern to use a ringing period of 2000 milliseconds and a
silent interval of 3000 milliseconds. This has the phone ring for two seconds, stop for three
seconds. Then it repeats.
36.10.3 voip pots ring show Command
Syntax:
voip pots ring show
ras> voip pots ring pattern 1 2000 3000