Chapter 36 voip Commands
Management Switch Card User’s Guide
1083
This command shows the POTS ring pattern settings. Here is an example.
36.10.4 voip pots ring voltage Command (MSC10124GC)
Syntax:
voip pots ring voltage DEFVAL|<voltage>
This command shows the POTS ring voltage.
36.11 voip sip cpt Command (MSC10124GC)
Use these commands to configure the VoIP SIP CPT (Call Progress Tone) timer mode.
36.11.1 voip sip cpt set Command (MSC10124GC)
Syntax:
voip sip cpt set <reorder> <howler> <alerting>
where
This command sets the CPT timer for VoIP SIP. By default, reorder is 10s, howler is 60s, and alerting is
600s.
ras> voip pots ring show
pots ring setting :
idx DEF name DEF on1 off1 on2 off2 on3 off3
------------------------------------------------------------------------------
1 - Test - 2000 3000
2 - Bellcore-dr2 - 800 400 800 4000
3 - Bellcore-dr3 - 400 200 400 200 800 4000
4 - Bellcore-dr4 - 300 200 1000 200 300 4000
5 - Bellcore-dr5 - 500 2000
6 - Bellcore-dr6 - 2000 4000
7 - Bellcore-dr7 - 2000 4000
8 - Bellcore-dr8 - 2000 4000
9 - Bellcore-dr9 - 2000 4000
10 - Bellcore-dr10 - 2000 4000
11 - Bellcore-dr11 - 2000 4000
12 - Bellcore-dr12 - 2000 4000
13 - Bellcore-dr13 - 2000 4000
14 - Bellcore-dr14 - 2000 4000
15 - Bellcore-dr15 - 2000 4000
16 - Bellcore-dr16 - 2000 4000
<reorder> =
re-order tone timeout. This indicates the local, toll switching, or transmission paths to the
office or equipment serving the called customer is busy This signal may indicate a
condition such as a timed-out sender or unassigned code dialed. Reorder tone timer
indicates that the duration of reorder tone (5~300s).
<howler> =
howler tone timeout. This informs a customer that their receiver is off-hook for a while.
Howler tone timer indicates that the duration of howler tone (5~300s).
<alerting> =
alerting tone timeout. This is the ring signal to inform caller and callee a phone call has
been sent or arrived. Alerting tone timer indicates that the duration of alerting tone
(60~1200s).
To Next Page
Loading...
