Chapter 4 Access Control List Screens
Management Switch Card User’s Guide
141
Figure 73 MAC Forced Forwarding Configuration Example 1
Example 2: Source is a Range of IPs or a Subnet
If you want to force all traffic between subscribers 1~8 and the server (S) to go through AR, you
can have the following settings. Note that 28 entered in the NetMask field indicates fifteen
subscriber devices are included.
Note: You have to calculate the netmask depending on the number of IP addresses you
want to include in a MAC forced forwarding rule.
Figure 74 MAC Forced Forwarding Configuration Example 2
Furthermore, to force all traffic between subscribers 9~16 and the server (S) through AR2, add
one more rule as shown. Note that 27 entered in the NetMask field indicates that thirty-one
subscriber devices are included. You can then monitor separated traffic centrally on AR or AR2.
To Next Page
Loading...
