Chapter 9 Subscriber Port Setup Screens
Management Switch Card User’s Guide
270
9.17 IPB Edgerouter Screen
Use this screen to set up and maintain edge routers in an IP bridge. Edge routers are usually the
gateways that are provided to the subscribers. They can also be the gateways that are specified in
static routing table entries. If two edge routers are in different domains, it is possible for them to
have the same IP address.
To open this screen, click Port > IP Bridge > Edgerouter.
Figure 172 IPB Edgerouter
Select Select the check box in the Select column for an entry and click Delete to remove the entry.
Note: You have to delete every IP bridge setting (including DHCP VLAN) that uses the selected
VLAN before you can remove it from the domain.
Select All Click this to select all entries in the table.
Cancel Click Cancel to start configuring this section of the screen again.
Index This field displays the number of the domain.
Name This field displays the name of each domain.
DHCP VLAN This field displays the VLAN where the domain’s DHCP server is located (or disabled if there
is no DHCP server for the domain).
Select
Modify
Delete
Select the radio button in the Select column for an entry. Click Modify to edit the entry or
Delete to remove it.
Table 121 IPB Domain (continued)
LABEL DESCRIPTION
To Next Page
Loading...
