ZyXEL Communications MSC1000G - The Advanced H248 Port Setup Screen

Chapter 9 Subscriber Port Setup Screens
Management Switch Card User’s Guide
294
9.27 The Advanced H248 Port Setup Screen
Use this screen to configure the VoIP settings of a port on your H.248 VoIP line card. Click a port
number in the Port H248 Setup Line Card screen (see Section 9.23 on page 286). The following
screen displays.
Note: The fields that display in this screen are the same as those in the H248 Port
Setup screen (see Section 9.25 on page 290).
Figure 190 The Advanced H248 Port Setup Screen
The following table describes the labels in this screen.
Port These are the numbers of the line card’s ports.
Click a port number to display the Advanced H248 Port Setup screen (see Section 9.27 on
page 294).
Enable Select a check box in this column to activate a port. Select the check box at the top of the
column to activate all of the line card’s ports.
Termination Enter the name for this port’s H.248 Termination. By default, the port’s Termination name is
“termX”, where X is the port number. Enter up to 31 alphanumeric characters. Spaces are not
allowed.
DSP Profile Select the digital signal processing profile the port is to use. If you have not configured any
profiles, only the default profile DEFVAL can be selected. Configure DSP profiles in the Profile
> VoIP DSP screen.
Select Use this column to choose a port from which you want to copy settings.
Table 133 Port > VoIP H248 Setup > H248 Port Setup Line Card Screen
LABEL DESCRIPTION
Table 134 The Advanced H248 Port Setup Screen
LABEL DESCRIPTION
UP Click this to return to the Port H248 Setup Line Card screen.
Enable Select the check box to activate H248-based VoIP on this port.
DSP Profile Select the digital signal processing profile the port is to use. If you have not
configured any profiles, only the default profile DEFVAL can be selected. Configure
DSP profiles in the Profile > VoIP DSP screen.
TEL This field displays the H.248 Termination name of the port. The Termination name is
assigned by the media gateway controller.
Customer Information Enter information to identify the subscriber connected to this port. You can use up to
31 printable ASCII characters (including spaces and hyphens).