Chapter 10 IMA Screens
Management Switch Card User’s Guide
317
10.3 Before You Begin
• Make sure all frames have either one or two VLAN tag(s) for multiple service providers to
differentiate their own traffic. You have to configure the VLAN settings for xDSL and the MSC
management line cards.
• Make sure E1 lines are physically connected properly to an IMA line card.
• Make sure you have enabled TLS (see Figure 147 on page 238 or Figure 195 on page 299) for
traffic before configuring a tagged PVC in the IMA > PVC screen for the traffic.
10.4 The IMA Group Setup Screen
Click IMA > GROUP in the navigation panel to open the following screen. Use this screen to
configure IMA group settings. You must configure the Minlink, Clk, Sym and Frame settings to be
the same as the remote IMA device.
Figure 208 IMA Group Setup
The following table describes the fields in this screen.
Table 148 IMA Group Setup
LABEL DESCRIPTION
Slot Select the number of an IMA line card’s slot.
Group Select the number of an IMA group on the line card.
Load Click Load to display the selected IMA group’s settings.
Enable Select this to enable the selected IMA group. Otherwise, clear this to disable it.
To Next Page
Loading...
