Chapter 13 Switch Screens
Management Switch Card User’s Guide
526
• VLAN-to-MST mapping
13.11.2.3 MST Instance
An MST Instance (MSTI) is a set of VLANs that use the same spanning tree. Each created MSTI is
identified by a unique number (known as an MST ID) known internally to a region. Thus an MSTI
does not span across MST regions.
The following figure shows an example where there are two MST regions. Regions 1 and 2 have 2
spanning tree instances.
Figure 359 MSTIs in Different Regions
13.11.2.4 Common and Internal Spanning Tree (CIST)
A CIST represents the connectivity of the entire network and it is equivalent to a spanning tree in
an STP/RSTP. The CIST is the default MST instance (MSTID 0). Any VLANs that are not members of
an MST instance are members of the CIST. In an MSTP-enabled network, there is only one CIST
that runs between MST regions and single spanning tree devices. A network may contain multiple
MST regions and other network segments running RSTP.
Figure 360 MSTP and Legacy RSTP Network Example
To Next Page
Loading...
