Chapter 14 Sys Screens
Management Switch Card User’s Guide
573
Figure 395 User Account
The following table describes the labels in this screen.
Table 308 User Account
LABEL DESCRIPTION
Enable Select this check box to activate the administrator account.
Name Type a user name for the account
Password Type a password for the account.
Retype Password
to confirm
Type the password again to make sure you have entered it properly.
Privilege Select the administrator account’s level of access privileges.
Select high to allow the administrator to perform all types of system configuration,
including the management of administrator accounts.
Select middle to allow the administrator to configure the system through the Web
Configurator but not manage administrator accounts.
Select low to allow the administrator read-only access to the Web Configurator screens.
Apply Click Apply to save the changes in this screen to the system’s volatile memory. The
system loses these changes if it is turned off or loses power, so use the Config Save link
on the navigation panel and then the Save button to save your changes to the non-
volatile memory when you are done configuring.
Cancel Click Cancel to begin configuring this screen afresh.
Index This column numbers the administrator account entries.
Enable This column displays a “V” if the administrator account is turned on or a “-” if the account
is turned off.
Name This column displays the user names of the accounts.
Privilege This column displays the level of access privileges of the accounts.
Delete Select one or more account entries’ check boxes and then use the Delete button to
remove it (or them).
To Next Page
Loading...
