ZyXEL Communications MSC1000G - Page 589

Chapter 14 Sys Screens
Management Switch Card User’s Guide
589
14.11.2.2 Attributes Used for Accounting Exec Events
The attributes are listed in the following table along with the time that they are sent (the difference
between Console and Telnet/SSH Exec events is that the Telnet/SSH events utilize the Calling-
Station-Id attribute):
14.11.2.3 Attributes Used for Accounting IEEE 802.1x Events
The attributes are listed in the following table along with the time of the session they are sent:
Table 317 RADIUS Attributes - Exec Events via Console
ATTRIBUTE START INTERIM-UPDATE STOP
User-Name Y Y Y
NAS-Identifier Y Y Y
NAS-IP-Address Y Y Y
Service-Type Y Y Y
Acct-Status-Type Y Y Y
Acct-Delay-Time Y Y Y
Acct-Session-Id Y Y Y
Acct-Authentic Y Y Y
Acct-Session-Time Y Y
Acct-Terminate-Cause Y
Table 318 RADIUS Attributes - Exec Events via Telnet/SSH
ATTRIBUTE START INTERIM-UPDATE STOP
User-Name Y Y Y
NAS-Identifier Y Y Y
NAS-IP-Address Y Y Y
Service-Type Y Y Y
Calling-Station-Id Y Y Y
Acct-Status-Type Y Y Y
Acct-Delay-Time Y Y Y
Acct-Session-Id Y Y Y
Acct-Authentic Y Y Y
Acct-Session-Time Y Y
Acct-Terminate-Cause Y
Table 319 RADIUS Attributes-Exec Events via 802.1x
ATTRIBUTE START INTERIM-UPDATE STOP
User-Name Y Y Y
NAS-IP-Address Y Y Y
NAS-Port Y Y Y
Class Y Y Y
Called-Station-Id Y Y Y
Calling-Station-Id Y Y Y
NAS-Identifier Y Y Y
NAS-Port-Type Y Y Y