Chapter 2 Hardware Connections
Management Switch Card User’s Guide
60
3 Insert the fiber-optic cables into the transceiver (you may need to remove cable dust covers).
4 Insert the transceiver into the slot with the exposed section of PCB board facing down.
5 Press the transceiver firmly until it clicks into place.
Figure 14 Transceiver Installation
Figure 15 Installed Transceiver
2.3.2.5 Transceiver Removal
Use the following steps to remove a mini GBIC transceiver (SFP module) from the slot.
1 Remove the fiber-optic cables from the transceiver.
2 Unlock the transceiver’s latch (latch styles vary).
3 Pull the transceiver out of the slot.
4 Put the transceiver’s dust cover on the transceiver.
Figure 16 Opening the Transceiver Latch
Figure 17 Removing the Transceiver
Console Port
Use the console port for local management of the MSC.
To Next Page
Loading...
