Chapter 16 VoIP
Management Switch Card User’s Guide
617
The following table describes the labels in this screen.
16.5 The VoIP Countrycode Screen
Use this screen to configure the regional VoIP settings of the IES, and to see details of the VoIP
settings affected by the country of operation you select. Click VoIP > Countrycode. The following
screen displays.
Figure 415 The VoIP > Countrycode Screen
Table 330 The VoIP > ARP Screen
LABEL DESCRIPTION
Slot Use the drop-down list box to select the active VoIP line card you want to manage.
Flush Click this to remove all the entries from the ARP table.
Refresh Click this to reload the information in the ARP table.
Index This is the ARP table entry number.
Slot This displays the line card number.
IP This is the learned IP address of a device connected to a port.
MAC This is the MAC address of the device with the listed IP address.
Timer This is the time (in seconds) until the entry expires (if there is no activity on the IP address).
Previous Click this to show the preceding ARP table screen (if the number of learned IP addresses cannot
be shown on a single page).
Next Click this to show the following ARP table screen (if the number of learned IP addresses cannot
be shown on a single page).
To Next Page
Loading...
