Management Switch Card User’s Guide 637
CHAPTER 17
Config Save
Use this section to save changes to your system’s configuration.
17.1 The Config Save Screen
Use this screen to save all configuration changes on to your MSC’s flash memory. If you do not use
this screen, any changes you have made to the system’s configuration will be lost once the MSC is
shut down.
Figure 428 Config Save
The following table describes the labels in this screen.
Table 344 Config Save
LABEL DESCRIPTION
Save Click Save to save your changes to non-volatile memory when you are done configuring.
Otherwise system configuration changes will be lost if the MSC is turned off or loses power.
To Next Page
Loading...
